 printable version
The lower section of the oil pan of the diesel engine of 2.5 liters
Remove the cap from the expansion tank.
| Fig. 6.34. Location screws heater exhaust pipe and additional heater noise insulation
|
Unscrew the heater exhaust pipe and additional noise insulation heater (Fig. 6.34).
| Fig. 3.4.2. Location screws bottom mudguard of a motor compartment
|
Remove the screws and remove the two sections of the bottom mudguard of a motor compartment (see. Fig. 3.4.2). Unscrew the bolts to the stabilizer bar underframe, lower it to 10 cm and secure in this position with a soft wire.
| Fig. 6.35. Arrangement of an electric socket of the gauge of level of engine oil
|
Disconnect the electrical connector from the oil level sensor (Fig. 6.35). Place under the engine capacity to collect the coolant. Remove the plug and drain the coolant. Remove the bolt of the pipe draining the coolant to the engine block. Install the engine under the tank for collecting engine oil. Drain the engine oil, which loosen the oil drain plug for about a half-turn. Place the container for oil gathering under the cap and remove the cap completely. If necessary, hold the cork while loosening that oil does not flow prematurely. When the oil is completely drained, screw the cap in place. Remove the bolts and remove the bottom section of the oil pan.
| 
