 printable version
Adjusting the position of the intermediate support propeller shaft
If there is, remove the four screws and remove the crossmember beneath the exhaust pipe. Remove the nuts securing the exhaust pipe connecting clamps, disconnect and remove the rear section of the exhaust system.
| Fig. 11.2. Location bolts thermofilter propeller shaft
|
Remove the bolt and thermofilter located above the propeller shaft (see. Fig. 11.2). Fit the plastic nut on the propeller shaft of the device 3139, holding the propeller shaft of the deflection. Remove the nuts and washers fastening intermediate support propeller shaft.
| Fig. 11.5. Setting intermediate support propeller shaft
|
Install the center bearing the PTO shaft so that the distance from the pole to the body as well (Fig. 11.5) was the same on both sides. Measure the distance and, depending on the distance to select the thickness of shims. Install liner on both sides under the support of the propeller shaft.
The distance (a) mm | Lining Thickness, mm | 0-3,0 | - | 3,1-5,0 | 2 | 5,1-7,0 | 4 | 7,1-9,0 | 6 | 9,1-11,0 | 8 | 11,1-13,0 | 10 |
|
