REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Audi A6 (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Audi
	A6
		General Information
		Operation of the vehicle
		Maintenance
		Engines
		Ignition, fuel injection and exhaust of gasoline engines
		The power supply system, and preheating the exhaust gases of diesel engines
		Lubrication System
		Cooling system
		Coupling
		Transmission
		The front wheel drive shafts
		Design features four-wheel drive transmission
		Suspension
			Overview
			Front suspension
			Front shock absorber
			Disassembly and assembly of the front shock absorber
			Rounded fist
			The sub-frame
			Front stabilizer
			Rear suspension
			Rear beam with bracket
			The hub of the rear wheel
			Front shock absorber
		Wheels and tires
		Steering
		Brakes
		Body
		Heating and air conditioning
		Electrical
		Electric schemes

printable version

Rear suspension

Fig. 12.20. Elements of design of the rear suspension front-wheel drive: 1 - lower spring seat; 2 - Mount the speed sensor; 3 - speed sensor; 4 - coil spring; 5 - a nave; 6 - an arm; 7 - a nut; 8 - a bolt, M12x1,5x90, 110 N ?� m; 9 - housing bracket; 10 - bolt 10 Nm; 11 - a bolt, M12x1,5x60, 110 Nm and tighten 90 ?�; 12 - a beam; 13 - a bolt, M14x1,5x190, 120 Nm and tighten 90 ?�; 14 - a belt; 15 - threaded holes

The rear suspension - independent. The guide element is a suspension bar consisting of two trailing arms and an amplifier, welded together. To a body rear beam mounted through the bracket with rubber bushings. To cushion the shock absorber are two and two springs located separately, resulting in increased boot capacity.

A WARNING

It is strictly forbidden to carry out welding and straightening work on the elements of the rear suspension. Necessarily make replacement of all the self-locking nuts and bolts with traces of corrosion.

NOTE

During assembly the nut 7 must be replaced and the screws 8, 11, 13 (Fig. 12.20).

« previos page
Setting

next page »
Rear beam with bracket