REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Audi A6 (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Audi
	A6
		General Information
		Operation of the vehicle
		Maintenance
		Engines
		Ignition, fuel injection and exhaust of gasoline engines
		The power supply system, and preheating the exhaust gases of diesel engines
		Lubrication System
		Cooling system
		Coupling
		Transmission
		The front wheel drive shafts
		Design features four-wheel drive transmission
			Overview
			The propeller shaft
				Withdrawal
				Setting
			Adjusting the propeller shaft
			Home reverse gear
			The rear drive shafts
			Differential main reverse gear
		Suspension
		Wheels and tires
		Steering
		Brakes
		Body
		Heating and air conditioning
		Electrical
		Electric schemes

printable version

Setting

Installation is made in sequence, return to removal, taking into account the following.

In the flange gearbox and rear axle, clean the threads of the bolt fastening the PTO shaft.

Check that the flanges of the propeller shaft did not have grease. Remove the new seals the protective film and place the gasket on the sticky side flanges to the propeller shaft.

Fig. 11.4. Location registration marks and bolts propeller shaft to the rear axle flange

To eliminate the imbalance align the marks on the propeller shaft flange to flange marks on the gearbox and rear axle (see. Fig. 11.4).

Secure the propeller shaft, using new bolts.

Adjust the position of the intermediate support propeller shaft.

Check that the exhaust system was located freely and does not touch the body.

NOTE

The maximum allowable deflection angle of the axis of the constant velocity joint - 8 ?�, universal joint - 25 ?�.

« previos page
Withdrawal

next page »
Adjusting the propeller shaft