REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Audi A6 (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Audi
	A6
		General Information
		Operation of the vehicle
		Maintenance
		Engines
		Ignition, fuel injection and exhaust of gasoline engines
		The power supply system, and preheating the exhaust gases of diesel engines
		Lubrication System
		Cooling system
		Coupling
			Overview
			Clutch Master Cylinder
			Bleeding of the hydraulic clutch
			The mechanism of the clutch
			Clutch plate
		Transmission
		The front wheel drive shafts
		Design features four-wheel drive transmission
		Suspension
		Wheels and tires
		Steering
		Brakes
		Body
		Heating and air conditioning
		Electrical
		Electric schemes

printable version

The mechanism of the clutch

Fig. 8.5. The mechanism of the clutch: 1 - Transmission; 2 - a stud with a ball stud, 25 Nm 3 - intermediate element; 4 - Belleville washer; 5 - O-ring; 6 - seal transmission input shaft; 7 - guide bush release bearing; 8 - fixing spring; 9 - the lever of the clutch; 10 - self-locking bolt, 35 Nm; 11 - clutch; 12 - a bolt, 20 Nm; 13 - the working cylinder of coupling; 14 - Pusher

NOTE

The convex side of the washer 4 (Fig. 8.5) must be directed to the guide sleeve.

When assembling the bolt 10 and the sealing ring 5 must be replaced.

Do not wash the clutch in a solvent, so as not to wash the grease from it. The bearing makes noise during rotation, should be replaced.

When installing the working surface of the clutch lever grease the Z 381 351 TE.

Fixing the spring 10 is attached to the release lever.

Ball pin 2 and the head of the pusher 14 (see. Fig. 8.5) are lubricated with grease based on molybdenum disulfide.

Fig. 8.6. The clutch slave cylinder

Before installing the clutch slave cylinder to gearbox housing must be the landing area as well (Fig. 8.6) Apply a thin layer of grease.

Fig. 8.7. Mount the clutch slave cylinder: 1 - a tube; 2 - a bolt; 3 - an arm; 4 - the working cylinder

Install and secure the working cylinder bracket tube (Fig. 8.7).

« previos page
Bleeding of the hydraulic clutch

next page »
Clutch plate