Running a car

Cars are of high quality workmanship and materials used, so they are immediately ready for full operation and does not require special running. However, in the initial period of operation of the vehicle (the first 1,000 kilometers) is an intensive burn-in details. To improve the reliability, durability and efficiency of the car at its further operation after an engine overhaul is recommended to perform the following rules of operation of the vehicle.

1. Before every departure, check and if necessary bring it to the rules of the air pressure in the tires.

2. Do not run the engine with the engine speed over 3000-3500 ^min -1.

3. In due time, in accordance with the road conditions go to a lower gear in order to avoid undesirable overloads motor.

4. For best break-in brake pads, avoid sharp braking.

5. As far as possible, avoid driving in deep snow, sand, mud.

6. Do not tow a trailer and, if possible, avoid towing other vehicles.

7. Use a "soft" style of driving, avoiding sudden acceleration, braking, maneuvering.

8. Do not exceed even the downhill speed of 130 km / h.

9. Periodically check and, if necessary, adjust the tension of the accessory drive belt (alternator and power steering pump, air conditioning compressor). In the initial period of operation the belts may be the most intense stretch.

10. Check the condition of the vehicle fasteners and tighten them if necessary. Pay special attention to mounting the wheels, steering parts, front and rear suspension, front pipe exhaust system to the engine exhaust manifold.

During the break-in (at run 1,000 km), visit the service station for the first planned maintenance. In order to guarantee continued to operate, require employees SRT entry in the service book stamps mark on maintenance.

After 1000 km of run restrictions are removed, but the running for the final details of the engine car must be about 3000 km.