printable version
Replace the ball joint spring strut
If the test has confirmed the need to support the change (see. "Check The front suspension on the car"), replace it. You will need: the keys "17" (two), "19", the key bolt wheel puller Ball joint, drill, drill for metal with a diameter of 12 mm. 1. Lift and set the front of the car on supports. Remove the wheel.
WARNINGS Slow down the car and set the parking brake at the rear wheel chocks ("boots"). Loosen or tighten the wheel bolts only on the car standing on the earth. |
| | 2. Remove the spring retainer nut finger of a spherical support. | 3. Remove the nut finger of a spherical support to the lever suspension ... |
| | 4. Install a stripper ... and press out the ball joint of the thumb lever. | 5. If the ball joint is attached to the lever studs (default), drill three rivets. |
6. If the support is bolted (it has changed), remove the three self-locking nuts, bolts from turning by holding the second key. A WARNING Locking nuts should not be reused, replace them with new ones. |
7. Remove the rivets (bolts) of the holes and the ball joint of the lever, and then remove the stand. 8. Replace the ball joint in the reverse order of removal. A WARNING When installing do not damage the protective cover of the ball joint. |
9. Lower the car to the ground several times strongly Push it. Tighten the nut finger ball bearings, and bearing bolts to the lever 70 N ?� m, install a spring clamp nut finger support.
NOTE After replacing the ball joint front axle, check and, if necessary, adjust the wheel alignment. Take advantage of workshops, have special equipment. |
|