add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks
Chevrolet Lanos
Home
 
Chevrolet
Lanos
Device Car
Operating Guidelines
Faults in the way
Maintenance
Engine
Transmission
Chassis
Front suspension
Design Features
Troubleshooting front suspension, their causes and remedies
Removal and installation of the shock absorber
Repair of the shock absorber
Replacing the top support of the shock absorber
Replace the ball joint spring strut
Replacing the arm front suspension
Replacement parts stabilizer bar front suspension
Replacing the front hub bearing
Rear suspension
A steering
The brake system
Electrical
Body
Wheels and tires
Purchase of spare parts
A trip to the STO
Winter car operation
Preparation for technical inspection
Tips novice mechanic
Applications
Diagrams
 


Hit Counter by Digits


print page printable version

Replacing the arm front suspension



You will need: the keys "12", "14", "17", "19", "22" face head "12", Round, Ball joint puller.
1. slow down the car and set the parking brake, wheel chocks ("shoes") under the rear wheels. Lift the front of the car jack and set it on supports. Remove the wheel.
A WARNING
Loosen or tighten the wheel bolts only on the car standing on the earth.

2. Remove the spring retainer, loosen the nut finger and press out the ball joint bolt (See. "Changing the ball joint shock absorber").
3. Unscrew the nut on the stabilizer bar and remove to a rack (see. "Replacement parts stabilizer bar front suspension").
4. Remove the two screws on the rear bracket support arm ...
5. ... and remove the bracket.
6. Remove the nut screw front support arm ...
7. ... remove the washer, remove the screw together with the second washer ...
HELPFUL ADVICE
If the bolt is not removed, knock it out of the bracket body, hitting the back of the arm.

8. ... and remove the lever assembly with the ball.
NOTE
Since the original front suspension lower control arms are supplied in parts assembled with the ball, and the hub Hobs back support, further dismantling of the lever does not make sense. You can only remove the parts are delivered separately in a sleeve of a back support that is easy to knock off the axle with a hammer.

9. Install the parts in reverse order of removal, without tightening definitively fixing rubber hinge arm and stabilizer bar.
10. Lower the car to the ground several times strongly Push it. Finally tighten the screw connections of suspension on the car standing on the earth, the values given in Appendix 1.

NOTE
After replacing the ball joint front axle, check and, if necessary, adjust the wheel alignment. Take advantage of workshops, have special equipment.




« previos page
Replace the ball joint spring strut
next page »
Replacement parts stabilizer bar front suspension

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.