REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Spectra (2004 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Spectra
		Device Car
		Operating Guidelines
		Faults in the way
		Maintenance
		Engine
		Transmission
		Chassis
		A steering
		The brake system
		Electrical
			Design Features
			Fault diagnosis onboard electric equipment
			Mounting blocks
			Accumulator battery
			Generator
			Starter
			The switch (lock) of ignition
			Ignition system
				Check and replacement of high-voltage spark plug wires
				Removing and installing ignition coils
			The engine management system
			Lighting, light and sound alarm
			Windscreen wiper
			Removing and installing windshield washer
			Removal and installation of the fan motor cooling radiator
			Fan heater
			Rear window
			Removing and installing cigarette lighter holder
			Device combination
			Replacing control lamps and instrument lighting
			Replacing control unit exterior rear-view mirrors and headlamp controller electroproof
			Replacing the instrument panel switches
			Replacing the backlight switches dashboard
			Refitting hours
			Removal and installation of the block ETWIS
			Car audio system
			Replacement sensors and switches
			Anti-theft immobilizer system
		Body
		Car Care
		Purchase of spare parts
		A trip to the STO
		Winter car operation
		Preparation for technical inspection
		Applications
		Diagrams

Removing and installing ignition coils

You will need: the keys "8", "12", a screwdriver with a flat blade and Phillips.

1. Disconnect a wire from the plug ?�-?� the storage battery.


2. Remove the decorative motor cover (see. "Removing and installing decorative casing of the engine").	3. Disconnect the ignition coil high-voltage wires.


4. Squeeze the latch and disconnect the connector harness from the condenser.	5. Having hooked a screw-driver, pull lock latch pad wiring harness.

6. Squeeze the clamp and disconnect the harness connector from the ignition coil.

7. Similarly disconnect the connector from the second ignition coil.


8. Remove the two screws on the bracket ignition coils ...	9. ... move aside the harness bracket ...


10. ... and bracket assembly from the ignition coil.	11. Remove the four screws nuts ignition coil to the bracket while holding the screws from turning ...

12. ... and remove the ignition coil.

13. Install the parts in reverse order of removal.