REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Spectra (2004 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Spectra
		Device Car
		Operating Guidelines
		Faults in the way
		Maintenance
		Engine
		Transmission
		Chassis
		A steering
		The brake system
		Electrical
			Design Features
			Fault diagnosis onboard electric equipment
			Mounting blocks
			Accumulator battery
			Generator
			Starter
			The switch (lock) of ignition
			Ignition system
			The engine management system
			Lighting, light and sound alarm
			Windscreen wiper
			Removing and installing windshield washer
			Removal and installation of the fan motor cooling radiator
			Fan heater
			Rear window
			Removing and installing cigarette lighter holder
			Device combination
			Replacing control lamps and instrument lighting
			Replacing control unit exterior rear-view mirrors and headlamp controller electroproof
			Replacing the instrument panel switches
			Replacing the backlight switches dashboard
			Refitting hours
			Removal and installation of the block ETWIS
			Car audio system
			Replacement sensors and switches
				Replacing the sensor signal lamp oil pressure
				Replacement of the gauge and fuel gauge sensor control lamp fuel reserve balance
				Replacement of the reverse gear switch
				Replacement and adjustment of the brake light switch
				Replacement of the switch signal lamp Handbrake
				Replacing the switch room lamp
			Anti-theft immobilizer system
		Body
		Car Care
		Purchase of spare parts
		A trip to the STO
		Winter car operation
		Preparation for technical inspection
		Applications
		Diagrams

Replacement of the gauge and fuel gauge sensor control lamp fuel reserve balance

You will need a flat-blade screwdriver.

1. Disconnect a wire from the plug ?�-?� the storage battery.


2. Remove the fuel pump module (see. "Replacement of the fuel pump").	3. Squeeze the clamp and disconnect the harness connector Sensor fuel level indicator.


4. Press the tabs ...	5. ... and disconnect the fuel gauge sender from a glass stick.


6. Bring the wire sensor control lamp fuel reserve balance of the glass groove drive, disconnect them from their holders ...	7. ... and disconnect the sensor from the cup storage by sliding it down.

8. Set the items in reverse order.

« previos page
Replacing the sensor signal lamp oil pressure