 printable version
Indication of time
| Fig. 1.95. The display mode of the current time
|
The display shows the current time when the ignition switch is in the ?�ON?� (ignition switched on) or "ACC" (auxiliary power consumers). If the displayed trip computer data, press the ?�CLOCK?� (hours) to switch the display to indicate the current time (Fig. 1.95).
NOTE On vehicles with trip computer, setting the clock, use the button ?�INFO?� (information) button instead of the ?�SET?� (setting). |
Setting the clock. a. Press and hold the ?�CLOCK?� (hours), until you hear a short beep. The display indicator lights "12Nr" or "24Nr" corresponding 12 and 24-hour time display mode. b. Click on the button ?�SET?�, to switch the 12 and 24-hour time display modes. This selected mode indicator flashes. In order to select the desired time display mode, press the ?�CLOCK?� (clock) again while the selected mode indicator continues to flash. at. Then the indicator lights ?�Hr. ADJUST ?�(Set the current time - the clock), and the two left discharge (hours) will flash. Press ?�SET?� set the required indication of the current time in the two left digits (hours), and then press the ?�CLOCK?� (hours). Then, the indicator lights ?�Min. ADJUST ?�(Set the current time - a minute), and two right discharge (minutes) will blink. Press ?�SET?� set the required indication of the current time in the two left digits (hours), and then press the ?�CLOCK?� (hours).
Change the clock. During the display of the current time, click on the button ?�SET?� and hold it for at least one and a half seconds. When you release the button, you will hear a short beep, and the clock will change as follows, for example: 12: 01-12: 29-12: 00 12: 30-12: 59-1: 00
NOTE When you release the button ?�SET?� reset discharge occurs seconds. |
| 
