 printable version
The index of temperature of the ambient air
System Manual microclimate. The display shows the ambient temperature when the ignition switch is in the ?�ON?� (ignition on).
The automatic climate control.
If the ignition switch is in the ?�ON?� (ignition on) to display the temperature reading of the ambient air, press the button "AMB" (ambient temperature), which is located on the climate control panel. Click on the "AMB" (ambient temperature) again to switch the display to indicate the temperature of the air in the passenger compartment that is set for the climate control system (Fig. 1.96). In some cases, the thermometer of the ambient air may be different from the actual temperature (depending on the ambient conditions and the state of the car): - Very low or high temperatures; - Sharp change of the ambient temperature; - The vehicle is stationary; - The vehicle is moving at a low speed.
The display of the automatic climate control system. The display shows the current status of the climate control system.
Display Audio. The display shows the current status of the audio system.
Trip computer display. Trip computer lets you control the display the following data: - Current fuel consumption; - Average fuel consumption; - Reserve of fuel remaining in the tank; - The average speed of the car.
Current fuel consumption. On the trip computer display shows the current value of the fuel consumption, which is calculated based on the fuel consumption and the distance traveled. Current fuel consumption is calculated and is updated every 2 seconds.
| Fig. 1.97. Displays the current fuel consumption
|
In the indication of the current fuel consumption display is lit ?�CONSUM CUR?� (Fig. 1.97). By reducing the speed of the car about 5 km / h readings of the current fuel consumption are replaced by symbols ?�- L / 100 km?�.
Average fuel consumption. On the trip computer display shows the value of the average fuel consumption, which is taken into account when calculating the amount of fuel consumed and the distance traveled by the vehicle since you last connected the battery to the onboard network, or since the last reset the trip computer. Fuel consumption is calculated and the display is updated every minute. In the average fuel consumption display, the display is lit ?�CONSUM AV?�.
In order to remove the trip computer, the displayed, click on ?�INFO?� (information) and hold it down for at least one second. After long pressing the ?�INFO?� (information) on the display shows the symbols ?�- L / 100 km?�, which will remain on display for one minute until a new value is calculated the average fuel consumption.
| Fig. 1.99. Indication of supply of fuel during vehicle
|
The display shows the approximate distance that can drive a car on the existing fuel in the tank. Reserve calculation is performed based on the average fuel consumption. Cruising range is recalculated and updated every minute. The display mode fuel reserve the display is lit ?�REMNG?�.
NOTE If the trip computer displays evidence of sufficient power reserve until the next refueling, immediately charge the vehicle's fuel tank when the fuel gauge needle in the tank is near the mark "E" (empty) or caught fire alarm minimum fuel. Indications on the trip computer display will not change if the tank is filled in less than 20 liters of fuel. |
The average speed of the vehicle. On the trip computer display shows the value of the average vehicle speed, calculated by distance traveled and time traveled since the last connection of the battery to the onboard network, or since the last reset the trip computer. The value of average vehicle speed is calculated and updated every 10 seconds.
In the display the average speed of the car on display is lit ?�AV?�.
| 
