 printable version
Setting code
Perform each procedure (1-3) for 10 seconds, otherwise the installation procedure code will be stopped. 1. Set the ignition switch to the ACC, and then turn off the audio unit. 2. First, press AUTO-M, then simultaneously press channel button 6 for approximately 2 seconds until the display shows ?«CODE?».
3. Press the AUTO-M again, then simultaneously press channel button 6 until the display shows a rectangle.
4. Select the personal identification code and write it down before entering. If you enter a number, and then forget it, if the power supply module unit will not function.
5. Channel selection buttons 1-4 are used to input the selected code. Button 1 sets the first digit, 2 - second 3 - third, 4 - the last digit. Enter a number within 10 seconds. If the display disappears, repeat the procedure, starting with the first.
NOTE Procedure 6 must be performed within 10 seconds after five treatments. |
6. At the time code display, press the AUTO-M, then simultaneously press channel button 6 for approximately 2 seconds. Indication ?«CODE?» will be displayed approximately 5 seconds. After the display disappears, the code number is set.
7. When the display shows ?«Err?» (error), repeat the procedure starting with 1. If the input error code repeats three times, set the ignition switch to the LOCK position and repeat the procedure from step 1.
| 
