 printable version
Removing and installing power steering pump
Remove the drive belt. Disconnect the pressure sensor connector. Disconnect the pressure line. Disconnect the suction hose.
| Fig. 5.30. Power-steering pump 1 - a belt; 2 - pressure sensor connector; 3 - penstock; 4 - suction hose; 5 - power-steering pump
|
Remove the three screws and remove the power steering pump.
| Fig. 5.32. Install the power steering pump in a vice with soft sponges
|
Secure the power-steering pump, using a special device (Fig. 5.32).
ATTENTION Use the special tool to prevent damage to the pump when mounting in a vise. |
Lift the ear clip using a flat-blade screwdriver.
| Fig. 5.33. Removing clamp power steering pump
|
Remove the clip with a flat-blade screwdriver and a hammer, as shown in Figure 5.33.
| Fig. 5.31. The components of the power steering pump: 1 - power-steering pump; 2 - pressure sensor; 3 - connector; 4 - O-ring; 5 - a control valve; 6 - a spring; 7 - a clip; 8 - a broad tank power steering; 9 - a sealing ring; 10 - Rear pump housing; 11 - a sealing ring; 12 - Clip; 13 - cam ring; 14 - a rotor; 15 - blade; 16 - side plate; 17 - a sealing ring; 18 - gland; 19 - a shaft; 20 - front pump housing
|
Disassemble the remaining components, guided by the order specified in Figure 5.31.
| 
