REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	3
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
			Overview
			Power supply system
			Lighting system
				Front combination lamp
				The rear combination lamp and internal combination lamp
				Removing and installing front combination lights
				Adjusting headlights
				Removing and installing the lamp lights
				Removal and installation of a gas discharge lamp lights
				Removing and installing parking lamp bulb
				Removing and installing front turn indicator
				Removing and installing the side direction indicator
				Adjusting the front fog light
				Removing and installing rear combination lamp
				Removal and installation of domestic combined lantern
				Removal and installation of a lantern of illumination of license plate
				Removing and installing additional brake light in the rear spoiler
				Removing and installing front interior light lamp
				Removing and installing the door switch
				Removal and installation of lighting lamps ashtrays
				Removing and installing ignition backlight
				Removal and installation of the backlight glovebox
				Removal and installation of lighting control switch on the dashboard
			Screen wipers and washer
			Immobiliser
			Electrical Inspections
			Tables
		Body

printable version

Removing and installing the lamp lights

Disconnect the negative battery cable.

Disconnect the front headlight combination.

Fig. 7.27. Removal Procedure headlamp components: 1 - a cover; 2 - a socket; 3 - lamp lights

Remove in the order indicated in Figure 7.27.

Loosen the wire clip lamp to remove the headlamp bulb.

Install in the reverse order of removal.

ATTENTION

During operation, the halogen lamp is heated to extremely high temperatures. If the surface is dirty lamp, the lamp will overheat, and its service life will be reduced. When replacing the lamp keep her base metal, not the bottle.

« previos page
Adjusting beam

next page »
Removal and installation of a gas discharge lamp lights