printable version
Replacing the engine oil
Install the vehicle on a horizontal surface. Warm up the engine to normal operating temperature. Stop the engine and wait 5 minutes. Remove the dipstick oil.
| Fig. 2.288. Checking the oil level on the oil level dipstick
|
Check the oil level - between F and L marks on the dipstick and evaluate the state of engine oil. If the oil level - below the label L, add oil (Fig. 2.288).
ATTENTION If during the oil change some of it accidentally gets into the working parts of the engine, wipe it off as thoroughly as possible. The remains are not wiped out by the oil can cause smoke in the engine compartment. |
Remove the oil filler cap and drain plug oil pan and oil filter. Drain the engine oil in a container. Install drain plug and oil filter with a new sealing ring. Tightening torque (drain plug oil filter): 9-10 Nm. Clean the drain plug flange of the oil pan) and replace the cap. Tightening torque (oil pan drain plug): 25-30 Nm. Again fill the engine motor oil of the specified type and in a specified amount.
|