 printable version
Setting code
Perform each procedure (1-3) for 10 seconds, otherwise the installation procedure code will be stopped. 1. Set the ignition switch to the ACC, and then turn off the audio unit. 2. First, press AUTO-M, then simultaneously press channel button 6 for approximately 2 seconds until the display shows ?�CODE?�.
3. Press the AUTO-M again, then simultaneously press channel button 6 until the display shows a rectangle.
4. Select the personal identification code and write it down before entering. If you enter a number, and then forget it, if the power supply module unit will not function.
5. Channel selection buttons 1-4 are used to input the selected code. Button 1 sets the first digit, 2 - second 3 - third, 4 - the last digit. Enter a number within 10 seconds. If the display disappears, repeat the procedure, starting with the first.
NOTE Procedure 6 must be performed within 10 seconds after five treatments. |
6. At the time code display, press the AUTO-M, then simultaneously press channel button 6 for approximately 2 seconds. Indication ?�CODE?� will be displayed approximately 5 seconds. After the display disappears, the code number is set.
7. When the display shows ?�Err?� (error), repeat the procedure starting with 1. If the input error code repeats three times, set the ignition switch to the LOCK position and repeat the procedure from step 1.
| 
