|
printable version
Removal and installation of the front suspension springs
 | When measuring the position of the body height and adjusting the angle of the front wheels ustanoski need to use special equipment company "Mercedes-Benz". |
| - In the engine compartment, unscrew the nuts of shock absorber to the upper pole of the body and remove the washer and rubber sleeve.
- Apply the parking brake, lift the front of the vehicle and substitute stops. Remove the wheels.
- Compress the spring jack-trolley, placing it under the lower arm.
- Replace the compression spring device, which should capture nine spring coils.
- Compress the spring on both sides. To facilitate the use of compression can be a jack mounted at the lower arm.
- Lower suspension arm and remove the spring from the car with a rubber cushion upper mounting.
- Rubber pads rotate left and remove. Install the spring longitudinally between the jaws of the bench screw and gradually loosen the coupling bolt fixtures
- Clean the top and bottom support springs and make sure that the drain hole in the lower bearing cup is not blocked.
- Spend fault detection spring clean and, if necessary, replace it with the proper. It is recommended to change both springs at the same time.
- Installation is the reverse order of removal. This should ensure that the lower coil spring mounted in a groove provided for the lower bearing cup. While tightening the nuts Strut front suspension to be loaded weight of the vehicle.
|
|
|
|