|
printable version
Removing and installing rear stabilizer bar
 | For vehicles with position control data of the body carried out by a qualified service station. |
| The section of the mount stabilizer bar |
Withdrawal | - Lift the rear of the car and set it on a stand (stand), placing emphasis under the front wheels.
- On vehicles equipped with the system controlling the position of the body, remove the screws and remove the control rod, noting its position on the stabilizer bar.
- Remove the rear wheels.
- Remove the nuts tip stabilizer bar to the connecting link and remove the links.
- Loosen the clamp bolts to the body and remove the plate and rubber grommet.
- Remove the rubber grommet exhaust pipe and lower it back on the stand.
- Remove the stabilizer bar from the vehicle.
- Spend fault detection components and, if necessary, replace them.
|
|
Setting Installation is the reverse order of removal with the placement of the points of bending the stabilizer bar in accordance with the design documentation (arrow). | Proper installation of the stabilizer bar rear suspension |
| - Do not tighten completely the nuts and bolts to full load suspension curb weight.
- Set the level of traction control systems of the body position at the station.
|
|
|
|