add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Almera (from 1995 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Nissan Almera
Home
 
Nissan
Almera
General Information
General requirements for car repair
Operation and maintenance of car
Petrol engines
Diesel engines
Transmission
Chassis
A steering
The brake system
Electrical
Body
Basic information
Body repair
Heating and ventilation system
Climate control (air conditioning)
Filling the air conditioning system
Removing and installing compressor
Removing and installing compressor drive belt
Removing and installing evaporator guard
The system of airbags and seat belt pretensioners
Applications
Scheme of electrical equipment
 


Hit Counter by Digits


print page printable version

Filling the air conditioning system



System charge is made only by means of special equipment at a gas station. If you want to perform some work in the engine compartment or in the repair of the body may be moving the air conditioner units, provided that the pipeline will not be disconnected. When undocking the refrigerant circuit need to replace the desiccant and oil in the compressor.

Location fittings air conditioning system
Fig. 9.47. Location fittings air conditioning system: A - gasoline engine;
B - diesel engine; 1 - high pressure nozzle; 2 - low-pressure nozzle



Location fittings installation shown in Fig. 9.47.

WARNINGS
When working with the refrigerant system should observe the following precautions.
1. Do not allow refrigerant to the skin, eyes and the respiratory tract. If this occurs, wash the affected areas with plenty of water, and then go to the hospital.
2. All work must be performed with refrigerant in a well-ventilated area. Note that the refrigerant is heavier than air, so the leak can accumulate in osmotrovyh ditches and other low-lying areas.
3. Vehicles with air conditioning not allowed to put into the drying chamber with a temperature of over 80 ?� C for more than 20 minutes.
4. When washing the engine compartment did not direct a jet of hot water on the air conditioner units.
5. For filling the air conditioner should be used only recommended by the manufacturer materials.
6. Do not smoke near the car when air conditioning system has been depressurised. In the case of depressurization of the system is required to replace the dryer.
7. It is strictly forbidden to repair the air conditioner units using welding or soldering.
8. If necessary, in the process of repair work units move the air conditioning system in the engine compartment it must be carried out without disconnecting the piping system.




« previos page
Climate control (air conditioning)
next page »
Removing and installing compressor

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.