| Some considered this Guide models equipped with airbags - mandatory disconnect SRS when servicing components located near the cushions (see chap. Onboard electric equipment). |
1. Follow the procedures of paragraphs 8 to 12 of Section Check, adjustment and replacement of a cable of a gear change. 2. Disconnect the cable of a drive key interlock solenoid valve lock switch and release it from the support bracket at the front of the base of the gear lever (see. Section Locking system switch transmission - the general information, check of a condition and replacement of components). | 3. Give two front nuts selector lever assembly. |
4. Poddomkratte car and establish it on props. 5. Give two bottom rear nuts selector lever to the floor. 6. In the car, disconnect all wiring, which can prevent the dismantling of the lever assembly, then separate the latter from the floor panel and remove it from the vehicle. 7. Install in the reverse order. Do not forget to adjust the drive cable (see. Section Check, adjustment and replacement of a cable of a gear change). |