|
|
 printable version
Service shock absorbers
Service shock absorbers Refitting Withdrawal | - Poddomkratte back of the car and establish it on props, the institution under the rear axle housing.
- Give a nut fastening the upper end of the shock absorber to the vehicle chassis. Remove the washers and rubber bushings (see. Accompanying illustration).
- Give the nut to the shock absorber lower support plate springs. Remove the washers and rubber bushings.
- Remove the shock absorber from the car.
|
|
Setting Installation is in the reverse order. | - Track correctness of installation of rubber bushings and washers fasteners.
- Track correctness of installation of the shock absorber. Dust sleeve must be facing downwards and is fitted on the lower end of the shock absorber.
- Tighten the upper retaining nut to 47 ÷ 65 Nm, the bottom - with a force of 17 ÷ 23 Nm.
|
|
Checking and bleeding  | The following describes the procedures for checking the state of the shock absorber to perform which do not require special equipment. |
| - Inspect the damper body for dents, other damage or leaks. A defective shock absorber restorative beyond repair and must be replaced.
- Check the condition of rubber plugs, in case of need make replacement.
- Hold shock absorber vertically in a vice (finger the lower leg).
- Grasp the top of the shock absorber and pull, lift up until it stops, then slowly lower down, fully compressing shock.
- Repeat the last paragraph six to eight times, completely eliminating backlash, detects the presence of a shock absorber in the air. If the backlash is not eliminated, the shock absorber must be replaced.
|
|
|
|
