|
|
 printable version
Removal and installation of the stabilizer of transverse stability
Withdrawal | - Poddomkratte the front of the car and establish it on props, the institution under the front axle housing.
- Give nuts rack rod to the brackets of the chassis and remove the washers and rubber bushings.
- Give nuts of ball joint rack stabilizer lateral stability and remove the rack from the car.
- Give bolts of support brackets rod stabilizer lateral stability to the crankcase of the front axle. Remove the bracket from the vehicle.
- Remove the anti-roll bar stability from under the car.
- If necessary, the transverse stability stabilizer brackets can be removed and the chassis of the car - Give fixing bolts.
|
|
Setting Installation is in the reverse order. | - Check the condition and track correctness of planting rubber pads in the brackets. Tighten the mounting bolts to 25 ÷ 32 Nm. When properly tightened bolts applying the paint marks on the stabilizer bar transverse stability should act equally on both sides.
- Check the condition of rubber plugs and, if appropriate equipment, ball joint rack stabilizer lateral stability, track correctness of landing components. Tighten the nuts of ball joint with a force of 25 ÷ 32 Nm.
|
|
|
|
