REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Patrol (from 1988 to 1997, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Patrol
		Introduction
		Troubleshooting
		Adjustment and routine maintenance
		Engine
		System of cooling, heating and air conditioning
		The power supply system and exhaust
		Systems for reducing emissions
		Systems of an electric motor
		Transmission
		Clutch
		Brakes
			Service brake master cylinder (GTZ)
			Service servo (servo) brakes
			Service front disc brakes
			Maintenance rear drum brakes
			Maintenance rear disc brakes
			Bleeding the hydraulic system
			Service brake pedal
			Removal and installation of the valve - the pressure regulator
			Service handbrake
		The front and rear axles, chassis and steering
		Body
		Onboard electric

printable version

Removal and installation of the valve - the pressure regulator

Withdrawal
PERFORMANCE ORDER
Poddomkratte back of the car and establish it on props.

Disconnect the drive from the valve spring (the location of the valve - the pressure regulator shown in the accompanying illustration).
Disconnect the brake pipe valve. Plug the open ends of the tubes in order to prevent excessive loss of fluids and to prevent ingress of dirt into the hydraulic system.
Give fixing bolts and remove the valve from the car.

Setting

Installation is in the reverse order.
PERFORMANCE ORDER
Tighten fixing bolts with demanded effort.
Bleed the brake system.
Spend car trial runs, checking serviceability of functioning of the valve - the pressure regulator. If the DC brake is locked rear wheel, should be given to the valve in the workshop of dealer branch of the manufacturer for the adjustment of the drive spring.
In no case do not try to disassemble the valve!

« previos page
Service brake pedal

next page »
Service handbrake