 printable version
The throttle cable - removal and installation
1. Remove the air filter. 2. Disconnect the cable from the valve body (see photo).
| 4.1 Fuel highway engines with fuel injection 1. Fuel Tube 2. The return gasoline 3. The selection of petrol vapor tube 4. Check valve 5. Fuel level sensor 6. Pump 7. Seal 8. Buck 9. Shield Tank (four-wheel drive and /
|
3. Apply the cuff and remove the cable from the slot in the bracket (photo). 4. Remove the bolts of the guide tube and pull the cable through a partition (photo). 5. Installation is performed in reverse order. Lubricate the sleeve with grease. Check the operation of the cable by pressing the pedal - damper should open completely. Adjust the cable sheath rotating nut. On vehicles with automatic transmission when you switch on the pedal rod downshift (kick-down- switch) must be fully retracted.
| 5.2a To disconnect a cable flap or cruise control, unscrew the nut and remove the cable cover. Then, pull the clutch hinged cables and remove the cables.
|
| 5.2b pedal and the throttle actuator 1. choke 2. Tube 3. Nylon cuff 4. Lock nut 5. The bracket and spring 6. Pedal 7. Lever 8. Cable 9. Clamp
|
| 5.3 Disconnecting the cable from the pedal
|
6. On vehicles with cruise control (automatic speed control) first, adjust the throttle cable, and then - a cable control.
| 
