 printable version
Withdrawal
The cylinder head of the engine 1,4-I 1 - the upper part of the toothed belt;
2 - the main gear belt.
Check the condition of the toothed belt. The direction of rotation of the toothed belt must not be changed. Do not bend a gear belt;
3 - support the toothed belt. The direction of rotation of the auxiliary gear belt should not be changed;
4 - a bolt, 10 Nm + tighten on a corner 90 ?�. When installing it is necessary to use new bolts;
5 - a casing high-voltage wires;
6 - the camshaft. When you install must be applied to the surface mating with the cylinder head, a thin layer of sealant AMV 188 VW-003 Install the camshaft produce vertically;
7 - a bolt, 10 Nm;
8 - pin;
9 - rocker. Before installation grease working surfaces of the rocker;
| | 10 - support element. With hydraulic valve clearance adjustment. The installation of the supporting members is made strictly in its place;
11 - a bolt of fastening of the cylinder head. When installing it is necessary to use new bolts. A tightening of bolts make in the same sequence as the engine 1,6- / 1,8-I;
12 - cylinder head;
13 - cylinder head gasket. When installing a new gasket;
14 - connecting the tension roller of a gear belt;
15 - a bolt, 20 Nm;
16 - a back casing of a gear belt;
17 - a bolt, 20 Nm;
18 - eyelet |
A warning  Common operations for the removal of the cylinder head are given in section 2.1.3.3.1. This section lists only the operations relating to the engine 1,4-I.
The engine I 1,4-camshafts mounted in a separate housing from the head camshafts.
| PERFORMANCE ORDER | | 1. Remove both toothed belt. |  | 2. Remove the bolt valve direction of exhaust gas (1) and bolt (2) electrical connector bracket. | | 3. Remove the back casing of a gear belt. | | 4. Gradually and consistently from the outside in, loosen and then remove the bolts camshaft housing. | | 5. Remove the camshafts. Remove the rocker with the support element and position them so that they stood up in the assembly into place. | | 6. Loosen the clamp and remove the thermostat housing coolant hose going to the water pump. |
|
|
