 printable version
Removal, installation, inspection of ceramic glow plugs
The order of execution of works
NOTE Remove and install the ceramic glow plugs straight. Remove damaged when installing components. |
Remove the engine cover. Remove the cylinder head cover. Remove the plugs with ceramic glow plugs. Remove the ceramic glow plugs with nozzles. Installation is performed in reverse sequence, with the following. Before installing, thoroughly clean the deposits from the holes in the cylinder head.
NOTE Do not grease the threads of the cylinder head and ceramic glow plugs. |
Screw the ceramic glow plugs via the nozzle into the cylinder head by hand. Then tighten the ceramic glow plugs. Tightening torque 12 Nm
ATTENTION After installation, before the first starting the engine, check the resistance of the ceramic glow plugs. |
Setpoint max. 1 ohm. If the received data is greater than a predetermined value - replace defective ceramic glow plug.
NOTE If a defective ceramic glow plug is snapped, you need to remove all the debris out of the engine, or the probability of damage to the engine. |
| 
