REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Audi A6 (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Audi
	A6
		General Information
		Operation of the vehicle
		Maintenance
		Engines
		Ignition, fuel injection and exhaust of gasoline engines
		The power supply system, and preheating the exhaust gases of diesel engines
		Lubrication System
		Cooling system
		Coupling
			Overview
			Clutch Master Cylinder
			Bleeding of the hydraulic clutch
			The mechanism of the clutch
			Clutch plate
				Removing the driven and clutch pressure plate
				Check clutch parts
				Install clutch
		Transmission
		The front wheel drive shafts
		Design features four-wheel drive transmission
		Suspension
		Wheels and tires
		Steering
		Brakes
		Body
		Heating and air conditioning
		Electrical
		Electric schemes

printable version

Clutch plate

A WARNING

When the clutch is formed dust containing asbestos is harmful to health, so the purification of the clutch, do not use compressed air and do not inhale the dust. Clutch parts clean from dust using the brake fluid, or methyl alcohol, and then wipe dry.

NOTE

When installing screws 2 (Fig. 8.8) must be replaced with new ones.

Lubricate the splines of the driven disk with a thin layer of grease G000100. A lubricant layer should be thin and uniform, since the clutch operation is excessive lubricant dropped on the clutch surface, which can disrupt its operation.

Fig. 8.8. Flywheel and clutch: 1 - dual-mass flywheel; 2 - bolt 60 Nm and tighten by 180 ?�; 3 - clutch plate; 4 - the pressure plate; 5 - bolt 22 Nm; 6 - the needle bearing

Tightening bolts 5 evenly over the "star."

« previos page
The mechanism of the clutch

next page »
Removing the driven and clutch pressure plate