Setting

Install the rear beam on the car.

Set bracket to its original position in accordance with the previously deposited stamped.

Tighten the brackets torque of 110 Nm, then turn at an angle of 90 ?�.

If you remove the rear spring, set them in place.

Install the shock absorber on the rear beam and secure it with a bolt and nut, tightening it to a torque of 110 Nm, then turn at an angle of 90 ?�. When tightening the nuts to the rear shock absorber beam car should stand on wheels.

Attach the wire speed sensor and brake tube clamp on the back of the beam (see. Fig. 12.24).

Install the speed sensor with the new rubber seal.

Clip the parking brake cables to the elements of the rear beam.

Install the brake calipers and fix bolts, having tightened their moment of 35 Nm.