 printable version
The right cylinder head cover
A WARNING All clips and clamps that when removing the cylinder head cover are damaged or cut, the assembly must be replaced with new ones. |
Withdrawal
| Fig. 3.2.1. Location screws engine cover
|
Remove the four screws and remove the engine cover (see. Fig. 3.2.1).
| Fig. 3.2.53. Location clamps securing the air pipe and tubing nuts filing (1) and Return (2) Fuel
|
Loosen the hose clamps and remove the air tube connecting the air flow meter and the intake manifold (see. Fig. 3.2.53). Release the three hose clamp on the housing of the cylinder head.
| Fig. 2.3.65. Location housing screws right cylinder head
|
Remove the bolt bracket pipe of the power steering cylinder head cover.
| Fig. 2.3.54. Location spark plugs.
|
A WARNING Do not remove the guide tube the oil level indicator, as would otherwise have to replace the O-ring at the base of the pipe. |
Remove the bolt of the oil dipstick tube to the cylinder head cover. Disconnect the crankcase ventilation hose from the cylinder head cover. Disconnect the cable and electric wires from the cylinder head cover and take them away.
| Fig. 2.3.66. Location nuts (1 and 2) from the cylinder head cover
|
Remove nuts 1 and 2 (Fig. 2.3.66) and remove the cylinder head cover.
Setting Installation is spent to sequences, return to removal, taking into account the following. If the gasket is damaged cylinder head cover, replace it.
| Fig. 2.3.64. Places applying sealant AMV 174 004 01 to the cylinder head gasket before installing
|
Apply a thin coat of sealant AMV 174 004 01 to the places shown in Figure 2.3.64. Tighten the nuts 1 (see. Fig. 2.3.66) fastening the cylinder head cover, then crosswise tighten the outer nut 2.
| 
