add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks
Chevrolet Lanos
Home
 
Chevrolet
Lanos
Device Car
Operating Guidelines
Faults in the way
The engine will not start
Fault injection system
Missing idling
Misfire
Diagnosis of engine appearance of spark plugs
The car moves jerkily
The car is badly dispersed
The engine has decayed during movement
Oil pressure dropped
Engine overheating
The battery is not recharged
Start the engine from the external power sources
Electrical Faults
There were extraneous knocks
Problems with brakes
Puncture
Maintenance
Engine
Transmission
Chassis
A steering
The brake system
Electrical
Body
Wheels and tires
Purchase of spare parts
A trip to the STO
Winter car operation
Preparation for technical inspection
Tips novice mechanic
Applications
Diagrams
 


Hit Counter by Digits


print page printable version

The car is badly dispersed



So located in the engine compartment components, failure of which affects the dynamics of the car.
The reasons for the deterioration of the dynamics of many, can be defined as basic.
1. Fault motor - reduction in the compression of one or more cylinders, suction of additional air into the intake tract of the engine. Coking of the exhaust system, or damage to the catalytic converter.
2. The power failure - clogged injectors, fuel filter and fuel system hoses. Insufficient supply of fuel pump. The use of low-quality fuel.
3. Faulty ignition system - failure of the spark plugs, the breakdown of the high voltage circuit of the system.
4. Faulty engine management system - failure of the sensor system. In case of refusal of a sensor electronic control unit goes to work on the backup program, which allows access to the garage or service center, but in this case, reduced power and economic characteristics of the engine.
5. clutch slippage due to wear or misalignment.
6. Faulty brakes - braking on one or more wheels in motion, improper adjustment of the parking brake.
7. Insufficient tire pressure.
8. Overloading the vehicle.
Full diagnostics of the car should be carried out highly skilled craftsmen using special diagnostic equipment, so please contact the service center.
Independently, you can perform the following operation.
1. Check and top up the air pressure in the tires.
2. Check the operation of the service brake system and parking brake. Filming for this wheel is not necessary. Find a flat stretch of road and in dry calm weather swipe check to determine the run-out of the car. The vehicle must be completely filled, only the driver in the cabin. Accelerate the vehicle to 50 km / h, line speed, and then turn off the transmission and drive to coast to a stop. Make another check in the reverse direction. Coast should be about 500 m.
3. Check the operation of the ignition system, as described above.
4. Check the operation of the clutch. Initial checks carried out on a level, a barrier-free site. The accelerator pedal, set a higher engine speed at idle - approximately 1,500 min -1. Brake the car a lay brake. Depress the clutch and including the I transmission. Then start slowly release the clutch. If the engine stalls, the clutch properly and stalled. If the engine does not stall, the clutch is worn and requires replacement or adjustment of the drive is turned off.

NOTE
The procedure of adjusting the clutch actuator can be found in Sec. 4 "Maintenance" (see. "Check and adjust the clutch drive").




« previos page
Jerks in steady movement
next page »
The engine has decayed during movement

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.