add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks
Chevrolet Lanos
Home
 
Chevrolet
Lanos
Device Car
Operating Guidelines
Faults in the way
Maintenance
Engine
Transmission
Chassis
A steering
The brake system
Design Features
Possible malfunctions of the brake system, their causes and remedies
Bleeding brake system hydraulic drive
Checking and adjusting the brake pedal position
The main brake cylinder
Vacuum brake booster
Replacement of hoses and tubes hydraulic brakes
Removing and installing brake pedal
Front brake
Rear brake
Removing and installing brake drum
Replacing brake pads Rear brake
Replacing the working cylinder of the rear wheel brake
Parking brake
Electrical
Body
Wheels and tires
Purchase of spare parts
A trip to the STO
Winter car operation
Preparation for technical inspection
Tips novice mechanic
Applications
Diagrams
 


Hit Counter by Digits


print page printable version

Replacing the working cylinder of the rear wheel brake



If during the operation there were streaks of brake fluid in the brake drum and the inner side of the wheel, or stuck piston in the cylinder, replace the slave cylinder.
You will need: the keys "9", "10" special key "10" for nuts, pipes, key to the wheel bolts.
1. Turn on the set and I transfer Chock the front wheels.
2. Remove a corresponding back wheel.
3. Remove any dirt from the brake pipe attaching bolts and the working cylinder on the back of a brake board.
4. Remove the brake drum (see. "Removing and installing the brake drum").
5. Lift the parking brake lever - upper ends of the pad will depart from stops pistons.
6. Remove the protective cap and turn the valve to remove the air.
7. Remove the nut of a brake tube to the working cylinder and plug the hole of the tube, such as a cap vent valve.

HELPFUL ADVICE
After prolonged use of a brake tube nut "fused" with a pipe in one piece, so when you try to unscrew the nut of the tube is twisted and broken. In this case, only a few stronte tube nut, then loosen the bolt cylinder and disconnect the tube, svinchivaya cylinder with its nut. After disconnecting the cylinder from the mobility of the released tube nut can be restored by moistening with brake fluid and turning nut wrench alternately in both directions.

8. Remove the bolt of the working cylinder, holding the cylinder with the other hand ...
9. ... and remove the working cylinder.
10. If the valve air release new cylinder is no protective cap, remove it from the old valve.
11. Install the slave cylinder in the reverse order of removal.
12. Install the brake drum (see. "Removing and installing the brake drum").
13. Adjust the rear hub bearings (see. "Adjusting the rear hub bearings").
14. Bleed the brake system (see. "Bleeding brake system hydraulic drive").
15. Several times sharply depress the brake pedal to bring the pads to the brake drum.




« previos page
Replacing brake pads Rear brake
next page »
Parking brake

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.