REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
			Technical data
			Drive shaft
			Drive shaft with SHRUS ball and Birfield type
			Drive shaft with SHRUS Birfield and tripoidnogo type
			A rotary fist and a nave of a forward wheel
			Rear axle
			Troubleshooting
		Suspension
		Steering
		Brakes
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

Drive shaft

1 - a lock ring;
2 - the drive shaft;
3 - strut front suspension;
4 - knuckle;

5 - Disc;
6 - a nut, 220-260 N ??? m;
7 - the lower arm.

Withdrawal

PERFORMANCE ORDER

1. Lift the car, fix on support and remove the front wheel.
2. Remove the nut of the drive shaft to the front wheel hub.
A warning When loosening the nuts of the drive shaft to a nave press the brake pedal to prevent the rotation of the wheel and the drive shaft.
3. Drain the transmission fluid from transmission.
	4. kapron hammer beat out a power shaft from the front wheel hub. If the drive shaft is firmly seated in the hub of the front wheel, spray impregnation spray solvent on the area of the splines and then re-screw the nut with flange so that it is flush with the end of the shaft. Striking on a nut a brass hammer, beat out a power shaft from a nave.
5. Reject the outside knuckle and remove drive shaft from the front wheel hub.
	6. Insert mount between an internal SHRUS drive shaft and a transmission and easy blow on mount take a power shaft from a transmission.
	A warning Relies on the mount rib gearbox housing. Do not insert the mount is very deep, so as not to damage the oil sealing ring. Do not pull the drive shaft, as this will be damaged by constant velocity joints.
7. Remove the drive shaft from the gearbox.
A warning Install drive shafts instead of a special plug to the gearbox dirt has not got. Each time you remove the drive shaft, replace the O-ring of differential.

Check

PERFORMANCE ORDER

1. Check the boot band of the drive shaft for damage and hardening rubber.
2. Check the ball joints for wear.
	3. Check the slots at the ends of the drive shaft for wear and damage.

Setting

PERFORMANCE ORDER

1. Grease a working edge of an oil sealing ring of differential.
2. Establish a new lock ring on the internal end of the drive shaft. A push, insert a power shaft into a transmission, thus a cut of a lock ring should be at the bottom.
3. After installation, pull out the drive shaft and make sure that it is securely round clip.
	4. Place the washer under the nut of the drive shaft to the hub of the convex side facing outward, as shown.

« previos page
Technical data