| 1. Check the engine oil level. Make sure the starter works normally, but the battery is fully charged. |
| 2. Start the engine and warm it to a temperature of 80-95 ?� C. |
| 3. Turn off the engine and remove the spark plug caps from the high-voltage wires. |
| 4. Remove the spark plugs. |
| 5. Turn the crankshaft of the engine. |
 | 6. Screw the tip compressometer in the spark plug hole. |
| 7. Fully open the throttle. |
| 8. the Starter cranked shaft of the engine about 4 turns on the scale and determine the compression device. Compression: 1.47 MPa
The minimum allowable compression: 1.37 MPa |
| 9. Repeat steps 6-8 on the remaining cylinders. |
10. If the compression is low in all the cylinders through the spark plug hole into the cylinders fill a few drops of engine oil and repeat steps 6-8.
1) If the oil filling compression raises perhaps worn piston rings.
2) If the compression is at the same level may be burned or damaged valves cylinder head gasket.
3) Replace the spark plug and connect them to the high-voltage wires. Torque: 20-30 N ??? m |
