 printable version
The front door
Refitting |  | - Remove the screw fastening of the internal handle and remove it from the door trim.
|
 | - Unscrew the door trim.
|
 | - Insert the removal tool between the door trim and door trim door and release the caps. Disconnect the electrical connectors.
|
 | - Remove the front door speaker and moisture proof film.
|
 | - Lower door window down and remove the screws that secure the glass.
|
 | - Remove the glass front door.
|
 | - Remove directing glass door.
|
 | - Remove the rear door channel.
|
 | - Remove the bolts of the outer door handle and lock the drive lock. Disconnect the connectors from the control box front door.
|
 | - Remove the control unit from the front door.
|
 | - Remove the outside rearview mirror.
|
|
|
Installation is performed in reverse order of removal. When installing the waterproof film should not be closed holes for fasteners door trim. Adjusting the doors Make sure that the door closes easily and properly. If the door is loose, tighten the bolts the door hinges.  |  | Attach the sealing tape to the edges of the wing, located opposite the door hinges. |
|
Impact plate door Make sure that the door closes easily and properly. If necessary, adjust the door as follows. | - If the door lock is mounted on a shock plate to work, remove the screws that secure the shock plate and moving it in the horizontal and vertical planes, achieve a normal door closing.
 | - Adjusting the position of the door relative to the adjacent surface of the wire by moving the shock plate in the vertical plane.
|
|
|
 |  | To check the smooth landing shock plate, pull the outside door handle outward and in this position, press the door to its closing position. |
|
|
