 printable version
Backdoor
Refitting |  | - Remove the screw fastening of the internal handle and remove it from the door trim.
|
 | - Unscrew the door trim.
|
 | - Insert the removal tool between the door trim and door trim door and release the caps. Disconnect the electrical connectors.
|
 | - Remove the front door moisture proof film.
|
 | - Lower door window down and remove the screws that secure the glass.
|
 | - Remove controlled glass tailgate.
|
 | - Remove the separation channel with the rear door, then remove the rear door glass.
|
 | - Remove the fixed glass rear door.
|
 | - Disconnect draft from the outside door handle. Remove the screws and lock the drive lock.
|
 | - Remove the control unit from the rear door.
|
 | - Installation is performed in reverse order of removal. When installing the waterproof film should not be closed holes for fasteners door trim.
|
|
|
Adjusting the doors Make sure that the door closes easily and properly, then check the uniformity of the gaps between the front and rear, top and bottom of the door and the body. Doors and faces of a body must be running in parallel. Impact plate door Make sure that the door closes easily and properly. If necessary, adjust the door as follows. | - If the door lock is mounted on a shock plate to work, remove the screws that secure the shock plate and moving it in the horizontal and vertical planes, achieve a normal door closing.
 | - Adjusting the position of the door relative to the adjacent surface of the wire by moving the shock plate in the vertical plane.
|
|
|
 | To check the smooth landing shock plate, pull the outside door handle outward and in this position, press the door to its closing position. |
|
