printable version

Jacking and towing

Poddomkrachivanie

The jack supplied with the kit to the car is intended solely for lifting it in the process of changing the wheels or to be mounted on a frame intravascular backup. IN NO EVENT does not perform any work under the vehicle and run the engine if the vehicle is locked in the raised position only through this jack.

The vehicle must be parked on level ground, the wheels are locked, and the transmission is in reverse gear position (Manual transmission) or <P> (Parking) (AT). In the case of forced stop on the track, coupled with the need for repairs do not forget to turn on the alarm system. If the wheel is to be replaced, after loosening its fastening screws a half-turn, and do not remove them until the wheel is off the ground.

Get a jack under the car in one of the points in the illustration. The slow flowing movements cock jack so that the wheel is off the ground. Remove the wheel and install in its place the spare tire. Loosely wheel nuts by tightening them by hand. Lower the car on the earth and tighten wheel nuts with torque wrench in diagonal order with demanded effort. Remember that some of the spare wheel designs are not designed for permanent use, but only for the delivery of the car to the place of repair - during a trip hazard, do not exceed the recommended maximum permitted speed and the path length (see. The instructions for use specific spare wheel).

The front and rear jacking points