REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Jeep
	Grand Cherokee
		Introduction
		Adjustment and routine maintenance
		The straight six-cylinder engine
		The V8 engine
		Procedure of the general and engine major repairs
		Systems of cooling, heating and air conditioning
			general information
			Antifreeze - the general information
			Check of functioning and thermostat replacement
			Check of serviceability and replacement of the cooling fan and clutch his clutch
			Check the operation and to replace the coolant temperature sensor
			Removing and installing radiator and cooling system expansion tank
			Check operation of the water pump
			Removal and installation of the water pump
			Check of an electric circuit and replacing the motor fan heater and air conditioner
			Removal and installation of the unit heater fan
			Removal and installation of assemblage of the control heater and air conditioner
			Removing and installing heat exchanger heater
			Check of serviceability and maintenance of heating systems and air-conditioning
			Diagnosis of automatic temperature control (ATC) without removing it from the car
			Removing and installing battery (accumulator) air conditioning system
			Removal and installation of the air conditioning system compressor
			Removal and installation of air conditioning condenser
			Removal and installation of a calibrated nozzle tube
			Removal and installation of evaporator air conditioning system
		The power supply system and exhaust
		The system of electric motor
		Systems of decrease in toxicity of the fulfilled gases and engine management
		Manual box of a gear change
		Automatic Transmission
		Transfer Case
		Clutch and transmission line
		Brakes
		Suspension and steering
		Body
		The system of on-board electrical equipment
		Controls and operation receptions

printable version

Systems of cooling, heating and air conditioning

Specifications

Common parameters

The amount of coolant	See. Chapter Settings and maintenance
Belt tension	See. Chapter Settings and maintenance
Design pressure radiator cap (kgf / ^cm 2)	0.98 - 1.26
The temperature of the beginning of opening of the thermostat	91 ?� C

Efforts of a tightening of carving connections, N ??? m

Bolts of fastening of the fan assembly to the hub (6-cylinder)	27
Bolts to the impeller clutch fan	24
Bolts of a cover of the thermostat housing	22
Bolts of fastening of the water pump to the block	9.5 - 12
Bolts of fastening of the water pump
6-cylinder engines	thirty
V8 engines	41
Bolts of fastening of the water pump pulley to the hub (engine V8)	27

« previos page
The first start of the engine after major repairs

next page »
general information