 printable version
Device combination
Location instrumentation, control and warning lights in the instrument cluster is shown in Fig. 1.7. The combination of devices, the following devices and alarms. 1, 13 - backup lamp. 2 - warning lamp turn on the rear fog lamp lights up when the light in rear fog lights. 3 - a control lamp of inclusion of the heated rear window. 4 - a control lamp of inclusion of headlights (with a light filter blue) lights up when the high beam headlamps. 5 - indicator lamp oil pressure (with a light filter in red) lights up when the ignition is switched on and warns that the pressure in the engine lubrication system is too low. Immediately after starting the engine light should go out.
A WARNING The movement of the car with the lamp burning is prohibited, as it will damage the engine. |
6 - E-type tachometer shows the engine speed of the engine. The scale has division from 0 to 8, the price of division 0.5. In order to know the engine speed in min -1, tachometer readings must be multiplied by 1000. The red zone - dangerous for the engine operation.
A WARNING While driving should be monitored readings tachometer - his hand, showing the engine speed should not be in the red zone. |
7 - a control lamp of inclusion of left turn indicator (green color filter with an arrow) will blink when the left-turn indicator in sync with him. Flashing warning lamp with doubled frequency signals blown lamps in any direction indicator. 8 - shows a speedometer the speed with which a vehicle is currently moving. Speedometer has two scales measuring the speed of a vehicle: in miles / hr and km / h. Scale of the vehicle speed in kilometers has divisions from 0 to 220 km / h and the division value of 20 km / h, and a scale measuring speed in miles from fission is 0 to 130 MPH with a scale division 10 MPH. 9 - Total mileage, combined with the counter of daily run. Total mileage shows the general path traversed by car. After run 1 million kilometers a new cycle begins counting. The counter of daily run can show the distance traveled by car for a trip or for a certain period of time. It works in two modes: ?�TRIP A?� and ?�TRIP B?�. Switched mode short (less than 1 second) by pressing the button 21 reset the trip counter. In the ?�TRIP A?� shows the distance traveled by the vehicle since the beginning of the current trip. Mode ?�TRIP B?� can be used to display the run after any intermediate point during the current trip.
NOTES The counter of daily run limited to a maximum value of 999.9 km. When disconnecting the battery trip counter reset. |
10 - a control lamp of inclusion of the right turn indicator (see. P. 7). 11 - coolant temperature in the engine cooling system. Move the arrow to the position of the device "H" warns of engine overheating. If the arrow is turned to "H", stop the car, allow the engine to cool down and remove the cause of overheating. 12 - warning light extra security (SRS). When the ignition light comes on for 6 seconds and then goes out. If the system of airbags and seat belt pretensioners fault has occurred, the lamp after the ignition stays on.
A WARNING If warning light comes on immediately contact service. Apart from the possible failure of pillows in an emergency, it can suddenly work on the road, which will lead to serious consequences. In addition, if at the time of the collision will not work pretensioners, seat may not prevent contact with the occupants of the car body elements. |
14 - the immobilizer warning light. It lights up when the ignition is switched on if the car is equipped with an immobilizer. After lamp ignition engine should start up within 4 seconds. After starting the engine warning light goes out. If the lamp goes off to start the engine, it is necessary to translate the key in the ignition switch to ?�LOCK?� and then start up the engine. If the lamp flashes for 5 seconds with the ignition on, then malfunctioning immobilizer.
A WARNING When a fault warning light immobilizer should immediately contact the service center. |
15 - the indicator light discharge battery (with a light filter in red) lights up when the ignition is switched on. Immediately after starting the engine light should go out. Burning lamps or glow dimly when the engine is running indicates the lack of charging current caused by the malfunction of the generator or voltage regulator, and a weak tension (or break) the alternator drive belt.
A WARNING The movement of the car with the lamp burning is prohibited, because, in addition to the complete discharge of the battery, it may indicate a circuit in the charging circuit, which can cause a fire. |
16 - status indicator light braking system (with red light filter). It lights up when the ignition is in the case of excessive loss of brake fluid in the master cylinder reservoir or elevated parking brake lever.
A WARNING Driving the vehicle with a burning warning light condition of brake system shall be prohibited. |
17 - open door warning light illuminates when any of the doors are not closed or not closed properly. 18 - warning light anti-lock braking systems (only for vehicles equipped with ABS). Lights up for 3 seconds with the ignition on and then goes out. If the light stays on, or lights up when driving does not come on after the ignition is switched on, it means that there is a fault in the system.
A WARNING If warning light immediately contact the service center. ABS fault If the effectiveness of the brake system is reduced, since the inhibition occurs in all cases without ABS. |
19 - the fuel gauge of the electromagnetic operating principle. Move the arrow in the bottom quarter of the scale is a reserve fuel remaining. 20 - a control lamp fuel reserve balance (with the orange color filter) is lit during the remainder of fuel in the tank is about 9 liters. Depending on the operating conditions of the vehicle and the remaining fuel would be enough to drive 40-50 km.
A WARNING If possible, avoid driving on the reserve balance of fuel. Employment elektrobenzonasosa without continuous supply of fuel to exposure in the air outlet of the pump will lead to failure. |
21 - Reset button for trip counter. By pressing the button and holding it for more than 1 set to zero the counter of daily run or switch modes of operation of the counter (see. P. 9). This will only reset the counter of the regime, which is indicated by its index on when you press the button. 22 - the indicator light Driver Seat Belt (with red light filter). It illuminates when the ignition is switched on and off after fastening the seat belt of the driver. In addition, when the ignition is switched on at the same time with the lamp is switched 10-11 with a warning buzzer. 23 - a control lamp overdrive lock (for vehicles equipped with automatic transmission). The lamp is lit with yellow light when blocking switching overdrive (fourth) transmission. 24 - a control lamp engine management system illuminates when the ignition and lights during engine start-up. Immediately after starting the engine light should go out. When lit the lamp with the engine running indicates a fault in the engine management system. The control unit switches to a backup program that allows you to continue driving. When the lamp is lit, check the engine management system to service and repair.
A WARNING Continuous operation of the car with a lighted lamp is not recommended because it can lead to increased fuel consumption, poor traction performance of the vehicle and damage the engine. |
| 
