REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Spectra (2004 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Spectra
		Device Car
		Operating Guidelines
		Faults in the way
		Maintenance
		Engine
		Transmission
		Chassis
		A steering
		The brake system
			Design Features
			Possible malfunctions of the brake system, their causes and remedies
			Bleeding brake system hydraulic drive
			The main brake cylinder
			Vacuum brake booster
				Replacement servo
			Replacement of hoses and tubes hydraulic brakes
			Front brake
			Rear brake
			Parking brake
		Electrical
		Body
		Car Care
		Purchase of spare parts
		A trip to the STO
		Winter car operation
		Preparation for technical inspection
		Applications
		Diagrams

printable version

Replacement servo

You will need: a flat-blade screwdriver, a ruler, a special key "10" for pipelines, face head "12" knob, extension cord, rubber bulb.

HELPFUL ADVICE

To loosen the hard nuts of the vacuum amplifier you will need a set of mechanical heads, extensions and drivers, similar to the one shown in the photo.

1. Disconnect a wire from the plug ?�-?� the storage battery.

2. Remove the brake master cylinder (see. "Replacing the brake master cylinder").

HELPFUL ADVICE

In the presence of the contractor sufficient skills master cylinder can not be removed completely, disconnect it from enough brake booster and take forward, without disconnecting from it pipelines.

3. Disconnect the vacuum hose from the nozzle of the vacuum amplifier (see. "Testing the brake servo").

4. Remove the fuse box, without disconnecting from it Pads with wires (see. "Removing and installing mounting block").


5. Remove the cotter pin, having picked up a screwdriver ...	6. Remove the metal washer ... ...


7. ... and remove the axis of the pusher of the vacuum amplifier.	8. Remove the four screws fixing the brake servo to the bulkhead panel ...

9. ... and remove the vacuum amplifier.

NOTE

If you removed the vacuum booster to replace, install a new vacuum booster pad and adjust the height of the brake pedal from the floor (see. "Checking and adjusting the brake pedal position").

10. Install the brake booster in the reverse order of removal.

« previos page
Vacuum brake booster

next page »
Replacement of hoses and tubes hydraulic brakes