add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Spectra (2004 release)

general info. full specifications. diagnostics. hints. tips. tricks
Kia Spectra
Home
 
Kia
Spectra
Device Car
Operating Guidelines
Faults in the way
Maintenance
General provisions
Daily maintenance (EO)
The first maintenance (1)
The second maintenance (TO-2)
Substitution coolant
Replacement of the fuel filter
Adjusting the throttle cable
Adjusting drive clutch
Replacing the hydraulic fluid in hydraulic clutch
Changing the oil in the gearbox
Check and adjust wheel alignment
Replacing brake fluid
Adjusting the parking brake
Adjusting headlights
Replacement and service of spark plugs
Cleaning the drainage holes of the body
Engine
Transmission
Chassis
A steering
The brake system
Electrical
Body
Car Care
Purchase of spare parts
A trip to the STO
Winter car operation
Preparation for technical inspection
Applications
Diagrams
 


Hit Counter by Digits


print page printable version

Replacement and service of spark plugs



According to the recommendations of the manufacturer conventional spark plugs need to be replaced every 45 000 km or 2 years whichever is the sooner. Candles with platinum or iridium-coated electrode should be replaced every 60 000 km or 4 years.
Recommended by the types of plugs and gaps between the electrodes are shown in Table. 13.3 and Annex 4.
You need a special key "16" to invert the spark plugs.
1. Remove the high-voltage wires from spark (see. "Checking and replacing the high-voltage spark plug wires").

NOTE
The key must be provided with a rubber grommet to hold a candle, or you will not be able to remove the candle from the candle well.

Replacement and service of spark plugs
Replacement and service of spark plugs
2. Remove the spark ...
3. ... and remove it from the candle well.

NOTE
Inspect the spark plug and evaluate its condition in appearance (see. "Diagnosis of engine appearance spark plug").

4. Clean the spark plug of dirt, rinse and dry in gasoline.

A WARNING
Candles with platinum or iridium coated electrodes can not be cleaned with a stiff brush to avoid the appearance on the soft surface of the electrodes scratches provoking soot deposits.

Replacement and service of spark plugs
Replacement and service of spark plugs
5. Check the circular probe electrode gap (see. Appendix 4).
6. If the backlash differs from specified, adjust it, bending the side electrode.
A WARNING
Adjust the gap only podgibaniem side electrode. Any bending of the center electrode will damage the insulator of a candle.

7. When installing the spark plug wrap them first hand (without knob) and then tighten the key. Do not exceed the torque specified in Annex 1.




« previos page
Adjusting headlights
next page »
Cleaning the drainage holes of the body

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.