REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Spectra (2004 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Spectra
		Device Car
		Operating Guidelines
		Faults in the way
		Maintenance
		Engine
		Transmission
		Chassis
		A steering
		The brake system
		Electrical
			Design Features
			Fault diagnosis onboard electric equipment
			Mounting blocks
			Accumulator battery
			Generator
			Starter
			The switch (lock) of ignition
			Ignition system
			The engine management system
			Lighting, light and sound alarm
				Design Features
				Replacing bulbs
				Replacing the headlight
				Replacing electroproof headlights
				Replacing the front fog lamp
				Replacing rear light
				Replacing rear fog light
				Replacement of an additional stoplight
				Replacing a side indicator lamp
				Replacing the license plate light
				Replacing the front room lamp
				Replacement of the central courtesy light
				Replacement of the trunk room lamp
				Replacing the steering column switch
				Removal and installation of the audio signal
				Replacement backlight ashtrays
			Windscreen wiper
			Removing and installing windshield washer
			Removal and installation of the fan motor cooling radiator
			Fan heater
			Rear window
			Removing and installing cigarette lighter holder
			Device combination
			Replacing control lamps and instrument lighting
			Replacing control unit exterior rear-view mirrors and headlamp controller electroproof
			Replacing the instrument panel switches
			Replacing the backlight switches dashboard
			Refitting hours
			Removal and installation of the block ETWIS
			Car audio system
			Replacement sensors and switches
			Anti-theft immobilizer system
		Body
		Car Care
		Purchase of spare parts
		A trip to the STO
		Winter car operation
		Preparation for technical inspection
		Applications
		Diagrams

printable version

Replacing the steering column switch

You will need a Phillips screwdriver with a blade.

1. Disconnect a wire from the plug ?�-?� the storage battery.


2. Remove the steering wheel (see. "Removing and installing the steering wheel").	3. Remove the steering column covers (see. "Removal and installation of the column cover").


4. Disconnect the pads Harness steering column switch.	5. Press the latch and disconnect the connector with a wire switch audio signals from the rotary switch.


6. Press tab harness pads contact the disc, as shown in the photos ...	7. ... and disconnect the connector.


8. Print the harness contact disc from the holder.	9. Remove the screws that secure the rotary switch to the steering column switch housing ...

10. ... and remove the pin drive.

WARNINGS

When installing the steering wheel to the steering shaft of the rotary switch must be in the neutral (middle) position but should be combined mobile and fixed 1 2 tags. To set the rotary switch to the neutral (middle) position, move the moving parts clockwise until it stops, then move it in the opposite direction 2.5 turns. Incorrect installation can cause damage to the rotary switch.

Contact neremontoprigoden drive, so if it fails, replace the disk assembly a new one.

HELPFUL ADVICE

In order to prevent mutual displacement of the moving parts of the rotary switch after its removal, fix them with adhesive tape.


11. Remove the three screws that secure the ...	12. ... and remove the shift paddles.

13. Set the switches and all the parts in reverse order of removal.

« previos page
Replacement of the trunk room lamp

next page »
Removal and installation of the audio signal