 printable version
Installation of child restraints
When installing a child restraint, follow all instructions of the manufacturer of a particular product. In order to secure the child restraint seat belt, which is transferred to the automatic locking mode, follow the instructions below. 1. Ensure secure the rear seat backrest. To do this, click on the back of the seat back until it engages. 2. Secure the child restraint using lap-lap diagonal seat belt. For instructions on wiring belt shown on the label of the child restraint.
3. To switch the inertia reel seat belt in the automatic locking mode dispensing belt, fully pull out the safety belt coil (Fig. 1.139). 4. Tightly install child restraint on the seat in the car. Make sure that the seat belt is fully retracted and stretched on inertia reel. When the inertia reel is switched to automatic locking mode, returning the belt to the coil will be heard clicks. If the seat belt is pulled and pressed firmly to the child restraint seat, repeat this step.
NOTE Check to automatically lock the seat belt before each use of the child restraint. If the retractable switched to automatic locking mode, the belt must not be issued when you try to pull it out from the reel. After removing the child restraint belt completely hand over to the inertia reel to switch its mode of emergency locking seat belt. Check the proper functioning of the seat belt before it's put on the passenger seat. |
| Fig. 1.140. Location of the bracket and the upper strap on Mazda vehicles 3: 1 - for the right location; 2 - to a central location; 3 - to the left; 4 - upper attachment straps; 5 - Cover
|
5. If the design of the child restraint provides its holder with the help of the top strap, lift the head restraint strap hook of the mounting bracket and tighten the strap. Follow the instructions of the manufacturer of the child restraint device (Fig. 1.140).
| 
