 printable version
Withdrawal
ATTENTION The gap between the switch signals of braking and the brake pedal is automatically adjusted when the brake light switch is placed in the hole on the brake pedal and turn to lock. If the circuit breaker braking signals are not installed properly, the gap may be incorrect, resulting in malfunction of the braking signal. Therefore, before installing the switch signals braking pedal, always check the correct installation and the position of the brake pedal (fully released). |
After the automatic adjustment of a backlash brake switch signal re-adjustment is not possible. Therefore, replace a new switch, the replacement of the brake booster or pedal, or performing any work in which the change pedal. Remove the battery and the battery area. Disconnect the brake line (from the master cylinder). Remove the bolts and nuts of the brake pedal. Pull the brake booster to the front of the vehicle so that the brake servo plug does not touch the lever of the brake pedal. Remove the brake pedal.
| Fig. 6.19. The procedure for removal of parts of the brake pedal: 1 - switch connector braking signals; 2 - switch braking signal; 3 - the accelerator cable; 4 - the accelerator pedal; 5 - the hinge axis; 6 - the brake pedal; 7 - supportive platform pedals
|
|
