REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	3
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
			Overview
			brake system
				Check and adjust the braking system
				Checking the brake fluid hydraulic drive braking system
				Removal of air from brake system
				Check the check valve vacuum hose (brake booster)
				Removal and installation of the vacuum hose (brake booster)
				Removing and installing brake pedal
					Withdrawal
					Setting
				Removal and installation of the main brake cylinder
				Check the fluid level sensor
				Removing and installing brake servo
				Check the brake servo
				Dismantling and assemblage of the master cylinder
				Removing and installing front brake disc
				Replacing the front brake pads
				Removing and installing rear disk brake
				Checking the parking brake system
				Removal, check and installation of the rear wheel speed sensor ABS
				Removal and installation of the hydraulic unit Anti-lock brake system
			Tables
		Onboard electric
		Body

Setting

Install the new hinge pin, plug the holes in the brake booster and brake pedals.

Fig. 6.20. Check the installation of the hinge axis

Make sure that the hinge pin plug regards brake booster completely (Fig. 6.20).

Check the brake pedal.

At full brake pedal, insert the new switch signals braking into the hole on the brake pedal.

Fig. 6.21. Turning the switch braking signal by 45 ?�

Fix the switch signals of braking, turning it counter-clockwise 45 ?� (Fig. 6.21).

NOTE

Adjusting the gap bolt limiter limiter pedal after the brake switch signal is securely locked, it is not required.

« previos page
Withdrawal