 printable version
Adjusting low beam
| Fig. 7.22. The scheme of adjustment dipped headlights
|
Set the screen to adjust the headlamp, as shown in Figure 7.22. Bring the tire pressure to normal. Place unloaded vehicle on a level surface. Put one person in the driver's seat. Place the vehicle upright and perpendicular to the wall. Install lights at a distance of 3 meters from the wall (Fig. 7.23).
When adjusting one headlamp, close the other. Start the engine to recharge the battery. Turn dipped. Set the headlight beam adjustment in the position 0.
| Fig. 7.24. Adjusting the rotation of the adjustment screws
|
Adjust the headlights by rotating the adjusting screws, as shown in Figure 7.24. First, loosen the screws, and then tighten them.
NOTE If at first tighten and then loosen the adjusting screws, they will turn away when the vehicle that will lead to a breach of the adjustment range. |
| Fig. 7.25. Driving the correct installation of the light beam
|
Rotating the adjusting screw to adjust the headlamp so that the point of intersection of the horizontal and inclined sections of light spots are in place, as shown in the shaded area of the figure 7.25.
| 
