add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)
general info. full specifications. diagnostics. hints. tips. tricks
 Mazda 3
Home
 
Mazda
3
Operation and maintenance of car
Engine
General description new engines models L8, LF, L3
The mechanical part of engines
Appendix 1
Annex 2
Appendix 3
Engine Z6 - mechanical part
Verify accessory drive belt
Check thermal gaps in the mechanism of the valve
Compression Test
Removing and installing timing chain drive
Replacing gaskets cylinder
Replacement of a forward epiploon of a cranked shaft
Replacing the crankshaft rear oil seal
Removing and installing engine
Withdrawal
Removing the main fuse block connector
Removing the engine mounts ?��3 and ?��4
Removing the engine mounts and ?��4
Installation and support of the engine ?��4
Install engine support ?��3
Lubrication system
Cooling system
Intake system
Fuel system
Exhaust and Emission
Ignition system
Control system
Tables
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Body
 


Hit Counter by Digits


print page printable version

Installation and support of the engine ?��4



Install engine support ?��1 and ?��4.

NOTE
During this operation, do not tighten the nut and bolt support of the engine ?��1 and ?��4.

Bolt support of the engine ?„–4
Fig. 2.284. Bolt support of the engine ?��4


Tighten the engine mount bolt ?��4, as shown in Figure 2.284.

The inhaling moment: 66,6-93,1 Nm.

Tightening the screws on the engine support bracket and ?„–4 battery
Fig. 2.285. Tightening the screws on the engine support bracket and ?��4 battery


Tighten the bolt and nut on engine mount bracket and ?��4 area battery in the order shown in Figure 2.285.
Torque:
1 - 44-61 Nm;
2 - 6,9-9,8 Nm.




« previos page
Removing the engine mounts and ?��4		 next page »
Install engine support ?��3

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.