 printable version
Installing cable lock
Make sure that the selector lever is in position P and the ignition switch to LOCK. Click on the lock mechanism and Abut in its bracket limiter brake pedal.
| Fig. 3.94. Fixing hook locking mechanism in the opening bracket
|
From this position, move the locking mechanism to secure the locking mechanism in the hook hole of the bracket, as shown below 3.94.
ATTENTION The bending or twisting the cable lock when setting can adversely affect the operation of the locking mechanism. |
| Fig. 3.95. Installing the cable end to the lock cam pin
|
Set the tip of a cable lock to the pin of the cam on the lever selector (Fig. 3.95).
| Fig. 3.96. Laying the cable lock into the groove of the base plate of the selector lever
|
Lay the cable lock into the U-shaped groove of the base plate and place the selector lever clamp (Fig. 3.96).
ATTENTION Applying pressure to the cable when installing the lock latch can adversely affect the operation of the locking mechanism. |
Click on the lock cable lock before it will be blocked.
| Fig. 3.97. Removing the pin locking mechanism
|
Remove the pin lock mechanism as shown in Figure 3.97. Turn the ignition key to the ACC. Install a cable lock to the key cylinder.
| Fig. 3.98. Installation of the clamp on the convex portion of the outer cylinder housing
|
Slide the outer casing to the cylinder of the key and set the clamp on the convex portion of the outer shell (Fig. 3.98).
| 
