add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)

general info. full specifications. diagnostics. hints. tips. tricks
Mazda 3
Home
 
Mazda
3
Operation and maintenance of car
Engine
Transmission
Clutch
Manual Transmission
Automatic transmission
Overview
Construction and operation of the transmission mechanism
The electronic control system (PCM)
The switching mechanism of the automatic transmission
The principle of the mechanism of automatic shift transmissions
Check the lock switch
Checking the ignition lock
Check the cable lock
Check selector lever
Adjust the gear selection cable
Adjustment of the switch range gearbox
Removing and installing selector lever
Installing cable lock
Drive Train
Tables
Chassis
Steering Gear
Brakes
Onboard electric
Body
 


Hit Counter by Digits


print page printable version

Removing and installing selector lever



The switching mechanism of the automatic transmission
Fig. 3.88. The switching mechanism of an automatic transmission 1 - facing the steering column (with a key locking mechanism); 2 - clip (key interlock mechanism); 3 - clip (key interlock mechanism); 4 - a cable lock (with the key interlock mechanism); 5 - a cable of a choice of transfer; 6 - the selector lever valve


The switching mechanism of the automatic transmission shown in Fig. 3.88.
Disconnect the negative battery cable.
Remove the battery and battery tray.
Remove the air filter.
Remove the console.
Remove the dashboard.
Remove the control module stability control system.

Removing the air conditioning control
Fig. 3.89. Removing the air conditioner control unit: 1 roping choke; 2 - unit air conditioner unit


Remove the air conditioner control unit (Fig. 3.89).
Remove the rear duct.
Remove the steering column trim.
Remove the clips and remove the cable lock and a cable gear selection.

NOTE
Installation is carried out in the manner indicated in Figure 3.88. Specific procedures for removal and installation described in this section.


Driving gear selection cable installation
Fig. 3.90. Driving gear selection cable installation


To install a cable of a choice of transfer, you must first install it on the bracket, as shown in Figure 3.90.
Before replacing the gear selection cable, check that the selector lever is in position P.

Lock cable lock gear selection (by the selector lever)
Fig. 3.91. Lock cable lock gear selection (by the selector lever)


Lock the cable lock gear selection (by the selector lever) in the order shown in Figure 3.91.

Check the manual shift shaft
Fig. 3.92. Check the manual shift shaft


Check that the manual shaft is in position P (Fig. 3.92).

ATTENTION
When installing the gear selection cable, hold it straight. Kinking rope gear selection, as shown in Figure 3.92, will result in damage to the cable, it can cause a weakening of the cable when switching.

Proper installation of the lever of the selector lever on the manual shift shaft
Fig. 3.93. Proper installation of the lever of the selector lever on the manual shift shaft



NOTE
Set the selector lever on the manual shift lever shaft so that the spring tip gear selection cable is facing toward the front of the vehicle (Fig. 3.93).

Set the selector lever on the manual shift lever shaft so that the gear selection cable was not loaded.
Make sure that the end of the lever of the manual shift shaft comes out of the tip of a cable gear selection.
Install selector cable into the bracket.




« previos page
Adjustment of the switch range gearbox
next page »
Installing cable lock

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.