REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	3
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
			Overview
			Mounted components of a body
				Removing and installing bonnet
				Adjusting the hood
				Removal and installation of the panel front wing
				Removing and installing front bumper
				Removing and installing rear bumper
				Door
				Removing and installing front door
				Removing and installing rear door
				Adjusting the door
				Adjusting tailgate
				Removing and installing the glass front door
				Removal and installation of glass of a back door
				Removal and installation of the block of the front door
				Removal and installation of the block back door
				Windows
			Glazing Body
			Seats
			Air conditioning and heating
			Tables

printable version

Removing and installing bonnet

To remove the hood hinges, remove the following items:

- The front side direction indicators;

- front bumper;

- Front combination lamps;

- Panel front fruit bats.

Disconnect the hose washer windscreen.

Fig. 8.7. Removing the hood: 1 - hood insulator; 2 - the seal housing; 3 - the separation of the seal; 4 - hood; 5 - hood hinges; 6 - support the hood; 7 - switch connector hood (with alarm system); 8 - lock hood; 9 - the bonnet release lever; 10 - wire bonnet

Remove in the order shown in Figure 8.7.

Install in the reverse order of removal.

Adjust the position of the hood.

« previos page
Mounted components of a body

next page »
Adjusting the hood